Help Center

Contact Support

What is involved in replacing a damaged flash suppressor on a threaded barrel?

Table of contents

Overview

If the barrel is 16" or longer the flash suppressor can be unscrewed and replaced. It is recommended that you use a set of barrel vise jaw blocks when removing or installing flash suppressors.

A replacement crush washer should also be used.

 

If the barrel is less than 16" long the suppressor has been permanently attached to bring the barrel up to 16" legal length. Bushmaster is not set up to do individual piecework on barrels such as replacing permanently attached flash suppressors. A shop like this one http://www.adcofirearms.com/shopservices_.cfm?page=shop offer this type of service.
You must to post a comment.