Help Center

Contact Support

Red Dot Sight 1X30ST

Overview

Instructional information for the Red Dot Sight 1X30ST

Caution:

Before mounting your red dot sight, be sure to read carefully the operating instructions of the sight.  Be sure that your gun is not loaded and the gun's safety switch is in the "Safe" position before you attempt to install your red dot sight.  Always follow safe gun handling procedures.

  • Always keep muzzle pointed in a safe direction.
  • Gun should be unloaded when not in use.
  • Be sure of your target and what is beyond it.
  • Always wear eye and ear protection when shooting.
  • Familiarize yourself with the gun you are using.

Installing battery:

The sight uses one 3V CR2032 (or equivalent) Lithium button cell. Unscrew the battery cover, insert new battery with + side up, replace and tighten the cover. Always remember to carry a spare battery with the sight.

Mounting the sight:

1X30ST has standard 30mm main tube and can be mounted using 30mm scope rings of appropriate height and rail type depending on the desired application. The sight comes with a pair of Weaver style rings mounted. Loosen ring screws at the top and take off the bottom clamping screws. Slide the scope rings onto the mounting rail on the gun and move the sight and the rings back and forth to adjust for desired placement. Be sure to leave sufficient clearance (min. 4 inches) between your eye and the end of the sight. Rotate the sight to position the windage screw horizontally and elevation screw vertically. Tighten the ring screws, upper ones first and then the bottom ones, to securely hold the sight in place.

Zeroing, Windage and Elevation Adjustments

Caution: Since Zeroing involves actual shooting of live rounds, it should be done at an approved shooting range or equally safe area. Be sure to use eye and ear protection when shooting.

Unscrew and take off the covers of Windage/Elevation screws. Use a screw driver or coin to adjust point of impact by turning the screws in the directions as needed. Each click of the adjustment screw moves the dot by 1" at 100 yards (by 1/2" at 50 yards).

Dot Intensity Adjustment

The sight is built with a CQB reticle dot which is more visible than the conventional small dot. The brightness of the reticle dot can be adjusted by turning the battery tower which is also th ON/OFF switch. The battery tower is marked with numbers that correspond to various light intensity settings. The sight is OFF when the battery tower is set at "0" position. ALWAYS MAKE SURE THE SIGHT IS TURNED OFF WHEN FINISHED USING THE SIGHT.

Storage

When not in use, use included lens cover to protect the lens. Always keep the sight in clean and dry place. When the sight is not going to be used for a long period of time, take out the battery from battery tower. Should the lens get dusty or dirty, use soft lens cloth to wipe clean.

 

red dot.PNG

You must to post a comment.